ON-VEHICLE INSPECTION
Inspection · Vehicles built Sep 2011 – Dec 2011
| INSPECT RADIATOR CAP SUB-ASSEMBLY |
- CAUTION:
- Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Visually check the radiator cap.

If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean it with water and finger scouring.
Check that rubber packing 1, 2 or 3 is not deformed, cracked or swollen.
Check that rubber packing 3 and 4 are not stuck together.
Measure the valve opening pressure.
Apply engine coolant to rubber packing 2 and 3 before using a radiator cap tester.

When using the cap tester, tilt it more than 30°.
Pump the cap tester several times, and check the maximum pressure.
- Pumping speed:
- 1 pump per second
- HINT:
- Even if the cap cannot maintain the maximum pressure, it is not a defect.
- Standard Judgment Criterion:
Item
Specified Condition
Standard
(for brand-new cap)
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
Minimum
(after using cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)
| INSPECT FINS FOR BLOCKAGE |
Check that the radiator and condenser are not blocked with leaves, dirt, or insects. Clean the hose connections.
If the fins are blocked, wash them with water or a steam cleaner.- NOTICE:
- If the distance between the steam cleaner and core is too close, the fins may be damaged.
- Keep the following injection distance.
- Standard Injection Distance:
Injection Distance
Injection Pressure
300 mm (11.8 in.)
2942 to 4903 kPa (30.0 to 50.0 kgf/cm2, 427 to 711 psi)
500 mm (19.7 in.)
4903 to 7845 kPa (50.0 to 80.0 kgf/cm2, 711 to 1138 psi)
- If the fins are bent, straighten them with a screwdriver or pliers.
- Never apply water directly onto the electric components.
- If the distance between the steam cleaner and core is too close, the fins may be damaged.
Dry the fins with compressed air.
