2011-2013 Land Cruiser · Service Manual Vehicle Interior

IG Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

  1. When the engine switch is turned on (IG), positive (+) battery voltage is applied to the certification ECU (smart key ECU assembly).

WIRING DIAGRAM

B159040E02

INSPECTION PROCEDURE


1. CHECK BASIC FUNCTION (POWER SOURCE MODE FUNCTION)
  1. Check the basic function of the power source mode function.

    OK:
    Basic function operates normally.



NG
GO TO ENTRY AND START SYSTEM (for Start Function) (Click here)
OK


2. INSPECT FUSE (IGN)
  1. Remove the IGN fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    IGN fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BATTERY AND BODY GROUND)
B188626E02
  1. Disconnect the E29 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E29-17 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E29-18 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Certification ECU Power Source Circuit (from Jan 2012)IG Power Source Circuit (from Jan 2012) →