IG Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
- When the engine switch is turned on (IG), positive (+) battery voltage is applied to the certification ECU (smart key ECU assembly).
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK BASIC FUNCTION (POWER SOURCE MODE FUNCTION) |
 |
Check the basic function of the power source mode function.
- OK:
- Basic function operates normally.
|
NG |
 |
|
| GO TO ENTRY AND START SYSTEM (for Start Function) (Click here)
|
|
|
| OK |
|
 |
|
| 2. INSPECT FUSE (IGN) |
 |
Remove the IGN fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
IGN fuse
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BATTERY AND BODY GROUND) |
 |
Disconnect the E29 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E29-17 (E) - Body ground
|
Always
|
Below 1 Ω
|
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
E29-18 (IG) - Body ground
|
Engine switch on (IG)
|
11 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|