2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Sep 2011


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Trouble Codes.

  5. Check for DTCs by following the directions on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Trouble Codes.

  5. Clear the DTCs by following the directions on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

← TERMINALS OF ECU (from Sep 2011)FAIL-SAFE CHART (from Sep 2011) →