2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2285 Steering Lock Position Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Sep 2011

Also covers:

DESCRIPTION

The main body ECU and the steering lock ECU are connected by a cable and the LIN communication line. These DTCs are stored when: 1) signals, transmitted through the cable and the communication line, do not match; or 2) a malfunction is detected in the circuit between the main body ECU and the steering lock ECU.
DTC Code
Detection Condition
Trouble Area
B2285
The cable and LIN information between the main body ECU and steering lock ECU is inconsistent.
  1. Main body ECU
  1. Steering lock actuator assembly (steering lock ECU)
  1. Harness or connector
B2288
After turning the engine switch from off to on (IG), the steering wheel does not unlock for a certain period of time (the ECU unlocks the steering wheel only when it receives an unlock signal from LIN communication and the cable).
  1. Main body ECU
  1. Steering lock actuator assembly (steering lock ECU)
  1. Harness or connector

WIRING DIAGRAM

C165201E03

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (STEERING UNLOCK SWITCH)
  1. Use the Data List to check if the steering lock is functioning properly.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Steering Unlock Switch
    Steering lock condition/ON or OFF
    ON: Steering unlocked
    OFF: Steering locked
    -
    Result 
    Result
    Proceed to
    Display on the intelligent tester does not change according to steering lock position
    A
    Display on the intelligent tester changes according to steering lock position
    B



B
REPLACE MAIN BODY ECU
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - STEERING LOCK ECU)
C164812E16
  1. Disconnect the E1 main body ECU connector.

  1. Disconnect the E26 steering lock ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-18 (SLP) - E26-4 (SLP1)
    Always
    Below 1 Ω
    E1-18 (SLP) or E26-4 (SLP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE MAIN BODY ECU
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check whether DTC B2285 and B2288 are output.

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output (for Power tilt and telescopic)
    B
    DTC output (for Manual tilt and telescopic)
    C



B
REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) (Click here)

C
REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) (Click here)
A

END


← B2284 Brake Signal Malfunction (from Jan 2012)B2286 Runnable Signal Malfunction (Sep 2011 – Dec 2011) →