2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2286 Runnable Signal Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main body ECU and ECM are connected by a cable and the CAN communication line. If the cable information and CAN information are inconsistent, this DTC is stored.
DTC Code
Detection Condition
Trouble Area
B2286
The cable and CAN information between the main body ECU and ECM is inconsistent.
  1. Main body ECU
  1. ECM
  1. Harness or connector

WIRING DIAGRAM

C165199E14

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ENGINE CONDITION)
  1. Use the Data List to check if the engine start is functioning properly.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Condition
    Engine condition/RUN or STOP
    RUN: Engine running
    STOP: Engine stopped
    -
    Result 
    Result
    Proceed to
    Display on the intelligent tester does not change according to engine condition
    A
    Display on the intelligent tester changes according to engine condition
    B



B
REPLACE MAIN BODY ECU
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)
A175405E02
  1. Disconnect the E3 main body ECU connector.

  1. Disconnect the A38 (for LHD) or A52 (for RHD) ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-8 (TACH) - A38-15 (TACH)*1
    E3-8 (TACH) - A52-15 (TACH)*2
    Always
    Below 1 Ω
    E3-8 (TACH) or A38-15 (TACH) - Body ground*1
    E3-8 (TACH) or A52-15 (TACH) - Body ground*2
    Always
    10 kΩ or higher

    HINT:
    *1: for LHD
    *2: for RHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE MAIN BODY ECU
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check whether DTC B2286 is output.

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output (for 1GR-FE)
    B
    DTC output (for 2UZ-FE)
    C
    DTC output (for 3UR-FE)
    D
    DTC output (for 1VD-FTV)
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECM (Click here)
A

END


← B2285 Steering Lock Position Signal Circuit Malfunction (+ B2288) (from Sep 2011)B2286 Runnable Signal Malfunction (from Jan 2012) →