2011-2013 Land Cruiser · Service Manual Vehicle Interior

SRS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Refer to "SRS Warning Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to "SRS Warning Light Remains ON" (Click here).

INSPECTION PROCEDURE

NOTICE:
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).


1. CHECK BATTERY
  1. Measure the voltage of the battery.

    Standard Voltage:
    11 to 14 V



NG
REPLACE OR RECHARGE BATTERY
OK


2. CHECK CONNECTOR
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the combination meter.

    OK:
    The connectors are properly connected.



NG
CONNECT CONNECTOR PROPERLY
OK


3. CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER)

  1. C173438E10
    Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Disconnect the E7 connector from the combination meter.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E7-18 (IG+) - E7-17 (B)
    Ignition switch ON
    11 to 14 V
    E7-17 (B) - E7-15 (ET)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK SRS WARNING LIGHT (SHORT TO GROUND)
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Connect the connector to the combination meter.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON.

  1. Check the SRS warning light condition.

    NOTICE:
    Make sure that nobody is in the vehicle.

    OK:
    After the primary check period, the SRS warning light goes off for approximately 10 seconds and then remains on.

    HINT:
    The primary check period is approximately 6 seconds after the ignition switch is turned to ON.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← SRS Warning Light Remains ON (from Jan 2012)SRS Warning Light does not Come ON (from Jan 2012) →