2011-2013 Land Cruiser · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use these procedures to troubleshoot the push-button start function.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, check if the CAN communication system is functioning normally.

      1. For LHD vehicles, use the following procedures (Click here).
      2. For RHD vehicles, use the following procedures (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output (for LHD)
      B
      DTC is output (for RHD)
      C


    B.

    C.
    A

    4.CHECK FOR DTC*
    1. Check for DTCs and note any stored DTCs (Click here).

    2. Clear the DTCs.

    3. Check whether the same DTC(s) relevant to the SFI system, EDU system or entry and start system recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.

      Result 
      Result
      Proceed to
      DTC output does not reoccur
      A
      SFI system DTC output reoccurs (for 1GR-FE)
      B
      SFI system DTC output reoccurs (for 2UZ-FE)
      C
      SFI system DTC output reoccurs (for 3UR-FE)
      D
      EDU system DTC output reoccurs (for 1VD-FTV)
      E
      Entry and start system DTC output reoccurs
      F


    B.

    C.

    D.

    E.

    F.
    A

    5.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Jan 2012)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012) →