Master Warning Light Malfunction
Circuit diagnosis · Vehicles built from Sep 2011
DESCRIPTION
If the steering control ECU detects that the VGRS system has a malfunction, warning information is transmitted to the combination meter via CAN communication.The combination meter will turn the master warning light on based on this information.
Warning information is transmitted via the following route:
- Steering control ECU → (CAN) → Network gateway ECU → (CAN) → Combination meter
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Check that there is no problem in CAN communication before performing the following procedure.
- If there are any problems in CAN communication, first troubleshoot them and then proceed to the troubleshooting below.
| 1. CHECK BATTERY |
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
Positive (+) battery terminal - negative (-) battery terminal
Always
11 to 14 V
|
|
||||
| OK | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (COMBINATION METER) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the master warning light turns on/off.
Combination Meter: Tester Display
Test Part
Control Range
Diagnostic Note
Master Warning
Master warning light
OFF/ON
Confirm that the vehicle is stopped and the engine is running
- OK:
- Indicator light turns on/off.
Result Result
ResultProceed to
NG
A
OK (for LHD)
B
OK (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
