Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
DESCRIPTION
When 2nd mode is selected with the pattern select (2ND) switch, the ECM controls the solenoid valves and the transmission starts from 2nd gear. The 2nd mode is the system that operates the throttle motor to control engine output to reduce skidding of the driving wheels, and guarantee takeoff acceleration, driving straightness and turning stability. When the shift lever is in D, the transmission automatically shifts up through 3rd to 6th as usual.
WIRING DIAGRAM
Refer to Pattern Select Switch Power Mode Circuit (Click here).
INSPECTION PROCEDURE
When the pattern select (2ND) switch is pushed, switch contact is made and 2nd mode is selected. To cancel 2nd mode, push the pattern select (2ND) switch once again.
HINT:
2nd mode is automatically canceled when the ignition switch is turned off.
1. DRIVING TEST
HINT:
The driving test should be performed on a paved road (nonskid road).
Start the engine.
Turn the 2ND switch off (normal drive mode).
Confirm vehicle response by driving from a parked position to fully depressing the accelerator pedal.
Turn the 2ND switch on and perform the same check as above.When driving the vehicle with the 2ND switch on and off, check that there is a difference in acceleration.