2011-2013 Land Cruiser · Service Manual Steering

C15A1/61 Actuator Malfunction

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

The steering control ECU drives the actuator while the steering wheel is turned to set the gear ratio. It detects the current flowing into the actuator motor driving circuit.
If the steering control ECU detects excessive current, it will store DTC C15A1/61, turn on the master warning light, and stop VGRS operation.
DTC Code
DTC Detection Condition
Trouble Area
C15A1/61
Excessive current (exceeding the estimated amount) flows due to a malfunction in the motor drive circuit.
  1. Harness or connector
  2. Steering actuator
  3. Steering control ECU

WIRING DIAGRAM

C163899E04

INSPECTION PROCEDURE

HINT:
When DTC C15A2/62 is output, a short circuit inside the steering actuator or inside the steering control ECU is suspected.


1. CHECK HARNESS AND CONNECTOR (STEERING CONTROL ECU - STEERING ACTUATOR)
C175599E01
  1. Disconnect the E78 steering control ECU connector.

  1. Disconnect the E80 steering actuator connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E78-1 (BMV) - E78-2 (BMU)
    Always
    10 kΩ or higher
    E78-1 (BMV) - E78-3 (BMW)
    E78-2 (BMU) - E78-3 (BMW)
    E78-1 (BMV) - E80-5 (BMV+)
    Always
    Below 1 Ω
    E78-2 (BMU) - E80-4 (BMU+)
    E78-3 (BMW) - E80-13 (BMW+)
    E78-1 (BMV) - Body ground
    Always
    10 kΩ or higher
    E78-2 (BMU) - Body ground
    E78-3 (BMW) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK STEERING ACTUATOR

  1. C149144E03
    Disconnect the E78 steering control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    HINT:
    The resistance must be measured with the steering actuator connector connected.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E78-1 (BMV) - E78-2 (BMU)
    Always
    Below 1 Ω
    E78-1 (BMV) - E78-3 (BMW)
    E78-2 (BMU) - E78-3 (BMW)
    E78-1 (BMV) - Body ground
    Always
    10 kΩ or higher
    E78-2 (BMU) - Body ground
    E78-3 (BMW) - Body ground

    Result 
    Result
    Result
    Proceed to
    NG
    A
    OK (for LHD)
    B
    OK (for RHD)
    C



B
REPLACE STEERING CONTROL ECU (Click here)

C
REPLACE STEERING CONTROL ECU (Click here)
A

REPLACE STEERING ACTUATOR ASSEMBLY (Click here)


← C1595/55 Lost Communication with Steering Angle Sensor Module (+ C15C4/68) (from Jan 2012)C15A2/62 Actuator Malfunction (+ C15A6/62) (Sep 2011 – Dec 2011) →