C15A5/65 Actuator Malfunction
Diagnostic trouble codes · Vehicles built from Sep 2011
DESCRIPTION
If the steering control ECU detects a malfunction in the lock mechanism, it will turn the master warning light on, store DTC C15A5/65, and stop VGRS operation.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C15A5/65 |
The steering control ECU detects that the LG terminal voltage is abnormal. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (STEERING CONTROL ECU - STEERING ACTUATOR) |


Disconnect the E79 steering control ECU connector.
Disconnect the E80 steering actuator connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E79-3 (LV) - E80-7 (LV+)
Always
Below 1 Ω
E79-12 (LG) - E80-16 (LG+)
E79-3 (LV) - Body ground
Always
10 kΩ or higher
E79-12 (LG) - Body ground
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E79-3 (LV) - Body ground
Engine switch on (IG)
Below 1 V
E79-12 (LG) - Body ground
|
|
||||
| OK | |
| 2. CHECK STEERING ACTUATOR (STEERING CONTROL ECU - STEERING ACTUATOR) |
![]() ![]() |
Disconnect the E79 steering control ECU connector.
Reconnect the E80 steering actuator connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E79-3 (LV) - E79-12 (LG)
Always
10 to 100 Ω
E79-3 (LV) - Body ground
Always
10 kΩ or higher
E79-12 (LG) - Body ground
Result Result
ResultProceed to
NG
A
OK (for LHD)
B
OK (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||

