2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the following procedure to troubleshoot the rear seat entertainment system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Inspect the battery voltage.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to next step.

    NEXT

    3.CHECK FOR DTC*
    1. Refer to DTC Check / Clear (Click here).

      Result 
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B

    2. HINT:
      If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the intelligent tester (Click here).


    B.
    A

    4.DTC CLEAR*
    1. Clear the DTCs and finish diagnostic mode.

      HINT:
      The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

    NEXT

    5.RECHECK FOR DTC*
    1. Recheck for DTCs.

      Result 
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B

      HINT:
      1. Even if the malfunction symptom cannot be confirmed, check for DTCs. This is because the system stores history DTCs.
      2. If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the intelligent tester (Click here).
      3. Check the DTC and inspect the area the code indicates.


    B.
    A

    6.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in the diagnostic trouble code chart (Click here).


    NEXT.
    7.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B

      HINT:
      If the symptom does not recur and no DTC is output, perform the symptom simulation method (Click here).


    B.
    A

    8.CHECK ECU TERMINAL ARRANGEMENT BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).

    NEXT

    9.CHECK CIRCUIT
    1. Adjust, repair or replace as necessary.

    NEXT

    10.RECHECK FOR DIAGNOSTIC TROUBLE CODE*

      HINT:
      After clearing the DTCs, recheck for DTCs.

    NEXT

    11.PERFORM CONFIRMATION TEST
      NEXT

      ← SYSTEM DESCRIPTION (from Jan 2012)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012) →