2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

TERMINALS OF ECU

System information · Vehicles built Sep 2011 – Dec 2011


DISPLAY AND NAVIGATION MODULE DISPLAY
E189961E07
Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
F64-1 (+B1) - F64-10 (GND1)
R - W-B
Power source (Back-up)
Always
11 to 14 V
F64-2 (ACC) - F64-10 (GND1)
GR - W-B
Power source (ACC)
Engine switch off
Below 1 V
Engine switch on (ACC)
11 to 14 V
F64-3 (IG) - F64-10 (GND1)
G - W-B
Power source (IG)
Engine switch off
Below 1 V
Engine switch on (IG)
11 to 14 V
F64-4 (MACC) - F64-10 (GND1)
W - W-B
Microphone AMP power supply
Engine switch off
Below 1 V
Engine switch on (IG)
4.5 to 5.5 V
F64-5 (MIN+) - F64-10 (GND1)
B - W-B
Microphone voice signal
See "Microphone & Voice Recognition Check" in Operation Check (Click here)
-
F64-6 (MIN-) - Body ground
R - Body ground
Microphone voice signal
See "Microphone & Voice Recognition Check" in Operation Check (Click here)
-
F64-7 (SGND) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
F64-12 (ILL+) - F64-10 (GND1)
G - W-B
Illumination signal
Light control switch off
Below 1 V
Light control switch tail or on
11 to 14 V
F64-16 (REV) - F64-10 (GND1)
L - W-B
Reverse signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
F64-17 (PKB) - F64-10 (GND1)
Y - W-B
Parking brake signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
F64-18 (SPD) - F64-10 (GND1)
V - W-B
Vehicle speed signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
F64-20 (SNS2) - F64-10 (GND1)
GR - W-B
Voice recognition and microphone connection detection signal
Always
Below 1 V
F64-21 (CANH)
P
CAN communication signal
-
-
F64-22 (CANL)
B
CAN communication signal
-
-
F64-23 (SWG) - Body ground
W - Body ground
Steering pad switch signal
Always
Below 1 V
F64-24 (SW2) - F64-23 (SWG)
P - W
Steering pad switch signal
No switch pushed
→ MODE switch pushed
→ On Hook switch pushed
→ Off Hook switch pushed
→ Voice switch pushed
4.44 to 5.43 V
→ 0.45 to 0.65 V
→ 1.19 to 1.49 V
→ 2.09 to 2.54 V
→ 3.2 to 3.88 V
F64-25 (SW1) - F64-23 (SWG)
L - W
Steering pad switch signal
No switch pushed
→ Seek+ switch pushed
→ Seek- switch pushed
→ Volume+ switch pushed
→ Volume- switch pushed
4.44 to 5.43 V
→ 0.45 to 0.65 V
→ 1.19 to 1.49 V
→ 2.09 to 2.54 V
→ 3.2 to 3.88 V
F60-7 (GND) - F64-10 (GND1)
B - W-B
Ground
Always
Below 1 V
F60-9 (TX2+)
W
AVC-LAN communication signal
-
-
F60-10 (TX2-)
L
AVC-LAN communication signal
-
-
F60-11 (ACC) - F64-10 (GND1)
GR - W-B
Accessory (ON)
Engine switch on (ACC)
11 to 14 V
Engine switch off
Below 1 V
F60-12 (+B) - F64-10 (GND1)
R - W-B
Battery
Always
11 to 14 V
F61-1 (AGND) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
F61-3 (VAR+) - F61-7 (VA-)
W - R
Sound signal (Right)
USB audio device playing (When stereo jack adapter used)
A waveform synchronized with sounds is output.
F61-4 (VAL+) - F61-7 (VA-)
B - R
Sound signal (Left)
USB audio device playing (When stereo jack adapter used)
A waveform synchronized with sounds is output.
F61-7 (VA-) - F64-10 (GND1)
R - W-B
Sound signal ground
Always
Below 1 V
F62-1 (HILL) - F64-10 (GND1)
W - W-B
Illumination signal
Light control switch off
Below 1 V
Light control switch tail or head (Light intensity is not max. or min.)
Pulse generation
F62-6 (SEUC) - F64-10 (GND1)
V - W-B
Security indicator signal
Security indicator operation
11 to 14 V
F65-1 (MI+)
W
MOST communication signal
-
-
F65-2 (SLDI) - F64-10 (GND1)
BR - W-B
Shield ground
Always
Below 1 V
F65-3 (MO+)
B
MOST communication signal
-
-
F65-4 (VMTR)*1 - F64-10 (GND1)
G - W-B
Visual mute signal
When image on display switches
4 V or higher → Below 0.7 V → 4 V or higher
F65-5 (MI-)
B
MOST communication signal
-
-
F65-6 (SLDO) - F64-10 (GND1)
BR - W-B
Shield ground
Always
Below 1 V
F65-7 (MO-)
W
MOST communication signal
-
-
F65-8 (WUO) - F64-10 (GND1)
R - W-B
MOST communication wake-up signal
Engine switch on (ACC)
4.5 V or higher
Engine switch off
Below 1 V
F66-1 (TX1+)*2
W
AVC-LAN communication signal
-
-
F66-2 (TX1-)*2
L
AVC-LAN communication signal
-
-
F66-4 (NTSO)*1 - F64-10 (GND1)
B - W-B
Display signal
DVD played on the display and navigation module display
A waveform synchronized with display signals is output.
(Refer to waveform 1)
F66-5 (V+)*3 - F64-10 (GND1)
R - W-B
Television camera image signal
Engine switch on (IG)
Shift lever in R
Under normal conditions
Pulse generation
(Refer to waveform 2)
Engine switch on (IG)
Shift lever in R
Camera lens covered, blacking out screen
Pulse generation
(Refer to waveform 3)
F66-6 (CA+)*3 - F64-10 (GND1)
B - W-B
Television camera power supply
Engine switch on (IG)
Shift lever in R
5.5 to 7 V
F66-9 (VV+) - F64-10 (GND1)
W - W-B
Display signal
DVD is playing
A waveform synchronized with display signals is output.
(Refer to waveform 4)
F66-14 (SGND)*1 - F64- 10 (GND1)
W - W-B
Ground
Always
Below 1 V
F66-15 (SLD2)*1 - F64-10 (GND1)
Shield - W-B
Shield ground
Always
Below 1 V
F66-16 (V-)*3 - F64-10 (GND1)
W - W-B
Ground
Always
Below 1 V
F66-17 (CGND)*3 - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
F66-20 (VV-) - F64-10 (GND1)
B - W-B
Ground
Always
Below 1 V
F67-1 (+B2) - F64-10 (GND1)
V - W-B
Battery
Always
11 to 14 V
F67-2 (ACC2) - F64-10 (GND1)
GR - W-B
Accessory (ON)
Engine switch on (ACC)
11 to 14 V
Engine switch off
Below 1 V
F67-4 (G) - F64-10 (GND1)
B - W-B
Ground
Always
Below 1 V
  1. *1: w/ Rear Seat Entertainment System
  2. *2: w/ Parking Assist Monitor System
  3. *3: w/ Rear View Monitor System

  1. E181025E15
    Reference (Oscilloscope waveform):

    1. Waveform 1

      Item
      Content
      Measurement terminal
      F66-4 (NTSO) - F64-10 (GND1)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      DVD is played on the display and navigation module display
      Text in Illustration 
      *1
      Synchronization Signal
      *2
      Video Waveform

      HINT:
      The video waveform changes according to the image output from the display and navigation module display to the television display assembly, but the synchronization signal does not change.

  2. E181025E15
    Reference (Oscilloscope waveform):

    1. Waveform 2 (under normal conditions)

      Item
      Content
      Measurement terminal
      F66-5 (V+) - F64-10 (GND1)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Engine switch on (IG), shift lever in R
      Text in Illustration 
      *1
      Synchronization Signal
      *2
      Video Waveform

      HINT:
      The video waveform changes according to the image from the television camera assembly.

  3. E196927E01
    Reference (Oscilloscope waveform):

    1. Waveform 3 (camera lens is covered, blacking out the screen)

      Item
      Content
      Measurement terminal
      F66-5 (V+) - F64-10 (GND1)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Engine switch on (IG), shift lever in R
      Text in Illustration 
      *1
      Synchronization Signal
      *2
      Video Waveform

      HINT:
      The video waveform changes according to the image that the television camera assembly projects.

  4. E181025E15
    Reference (Oscilloscope waveform):

    1. Waveform 4

      Item
      Content
      Measurement Terminal
      F66-9 (VV+) - F64-10 (GND1)
      Measurement Setting
      200 mV/DIV., 10 μs/DIV.
      Condition
      DVD is playing
      Text in Illustration 
      *1
      Synchronization Signal
      *2
      Video Waveform

      HINT:
      The video waveform changes according to the image input from the radio receiver assembly to the display and navigation module display, but the synchronization signal does not change.


NAVIGATION MODULE BOARD
E180332E04
Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
F68-1 (+B) - F68-5 (G)
V - B
Battery
Always
11 to 14 V
F68-3 (ACC) - F68-5 (G)
GR - B
Power source (ACC)
Engine switch off
Below 1 V
Engine switch on (ACC)
11 to 14 V
F68-5 (G) - Body ground
B - Body ground
Ground
Always
Below 1 V

RADIO RECEIVER ASSEMBLY (Click here)

STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)

MULTI-MEDIA INTERFACE ECU (Click here)

TELEVISION DISPLAY ASSEMBLY (w/ Rear Seat Entertainment System) (Click here)

PARKING ASSIST ECU (w/ Parking Assist Monitor System) (Click here)
← PROBLEM SYMPTOMS TABLE (Sep 2011 – Dec 2011)DTC CHECK / CLEAR (Sep 2011 – Dec 2011) →