Parking Brake Switch Circuit
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
This circuit is from the parking brake switch assembly to the display and navigation module display.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK BRAKE WARNING LIGHT |
Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.
- OK:
- The brake warning light operates as specified above.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH - DISPLAY AND NAVIGATION MODULE DISPLAY) |
Disconnect the F64 display and navigation module display connector.
Disconnect the E53 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F64-17 (PKB) - E53-1
Always
Below 1 Ω
F64-17 (PKB) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 3. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
Disconnect the parking brake switch assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - Switch body
ON (When shaft is not pressed)
Below 1 Ω
1 - Switch body
OFF (When shaft is pressed)
10 kΩ or higher
|
|
||||
| OK | ||
| ||
