2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Sep 2011


1. INSTALL REAR WIPER RUBBER

  1. E156177
    Install the rear wiper rubber to the 2 rear wiper rubber backing plates.

    NOTICE:
    Install the backing plates in the correct direction.

  1. E156178
    Insert the rear wiper rubber from the claw position of the middle of the rear wiper blade to the end.

  1. E156179
    After passing the rear wiper rubber through the rear end side claw, allow it to stick out from the rear end stopper and slide it through the front tip side claw.


2. INSTALL REAR WIPER BLADE
  1. Hold the wiper blade at the same angle it was removed at and attach the claw to install it.

← REMOVAL (from Sep 2011)COMPONENTS (from Sep 2011) →