Radio Receiver Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit provides power to the multi-media module receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the multi-media module receiver assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F77-12 (GND1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F77-15 (IG) - Body ground
Engine switch on (IG)
11 to 14 V
F77-16 (ACC1) - Body ground
Engine switch on (ACC)
11 to 14 V
F77-17 (+B1) - Body ground
Always
11 to 14 V
| *a |
Front view of wire harness connector (to Multi-media Module Receiver Assembly) |
|
|
||||
| OK | ||
| ||
