2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Stereo Component Amplifier Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM

E182616E06

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND)

  1. E185602E09
    Disconnect the F2 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F2-2 (GND) - Body ground
    Always
    Below 1 Ω
    F2-6 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F2-1 (+B) - F2-2 (GND)
    Always
    11 to 14 V
    F2-3 (+B2) - F2-2 (GND)
    Always
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Stereo Component Amplifier Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Radio Receiver Power Source Circuit (from Jan 2012)Stereo Component Amplifier Power Source Circuit (from Jan 2012) →