DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| READ DATA LIST |
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
Combination Meter Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
P-Seatbelt Buckle SW*1
Front passenger side seat belt buckle signal / ON or OFF
ON: Front passenger side seat is occupied, front passenger side seat belt is fastened
OFF: Front passenger side seat is occupied, front passenger side seat belt is unfastened
-
D - Seatbelt Warning Buzzer*2
Driver side seat belt warning signal / ON or OFF
ON: Driver side seat belt warning buzzer is sound
OFF: Driver side seat belt warning buzzer is not sound
The current customize setting is displayed.
P - Seatbelt Warning Buzzer*1, *2
Front passenger side seat belt warning signal / ON or OFF
ON: Front passenger side seat belt warning buzzer is sound
OFF: Front passenger side seat belt warning buzzer is not sound
The current customize setting is displayed.
- *1: w/ Airbag System
- *2: w/ Seat Belt Warning Buzzer
SRS Airbag (w/ Airbag System) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Driver Buckle SW
Driver side seat belt / Set, Unset or NG
Set: Driver side seat belt is fastened
Unset: Driver side seat belt is unfastened
NG: Data is not determined
Passenger Buckle SW
Front passenger side seat belt / Set, Unset or NG
ON: Front passenger side seat is occupied, front passenger side seat belt is fastened
OFF: Front passenger side seat is occupied, front passenger side seat belt is unfastened
-
Main Body (w/o Airbag System) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D Seat Buckle SW
Driver side seat belt / ON or OFF
ON: Driver side seat belt is fastened
OFF: Driver side seat belt is unfastened
-
- *1: w/ Airbag System
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to display on the intelligent tester, perform the Active Test.
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
Driver Side Seat Belt
Driver side seat belt warning light
ON/OFF
Confirm that the vehicle is stopped and the engine is idling.
Front Passenger Side Seat Belt*
Front passenger side seat belt warning light
ON/OFF
Confirm that the vehicle is stopped and the engine is idling.
- *: w/ Airbag System
- *: w/ Airbag System