ON-VEHICLE INSPECTION
Inspection · Vehicles built from Sep 2011
| REMOVE PTC HEATER RELAY (PTC HTR 1, PTC HTR 2, PTC HTR 3) |
![]() ![]() |
Remove the 3 PTC heater relays from the engine room relay block.
| INSPECT PTC HEATER RELAY (PTC HTR 1, PTC HTR 2, PTC HTR 3) |
![]() ![]() |
Measure the resistance of the relay.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Battery voltage not applied between terminals 1 and 2
10 kΩ or higher
Battery voltage applied to terminal 1 and 2
Below 1 Ω
- If the result is not as specified, replace the relay.
| INSTALL PTC HEATER RELAY (PTC HTR 1, PTC HTR 2, PTC HTR 3) |
![]() ![]() |
Install the 3 PTC heater relays to the engine room relay block.



