2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2761 Intrusion Sensor Internal Circuit Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

  1. The intrusion sensor conducts a self-diagnosis immediately after the power is supplied to the sensor (when the theft deterrent system is set).
    If a malfunction is detected in the intrusion wave transmission or wave reception, or the intrusion sensor wave transmission or wave reception circuit, the intrusion sensor sends a signal to the certification ECU (smart key ECU assembly). The ECU then outputs this DTC.
DTC Code
DTC Detection Condition
Trouble Area
B2761
The intrusion sensor outputs a signal for a sensor malfunction.
  1. Intrusion sensor
  2. Map light assembly
  3. Certification ECU (Smart key ECU assembly)

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Set the theft deterrent system and check if the same DTC is not output.

    OK:
    DTC B2761 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK INTRUSION SENSOR (OPERATION)
  1. Temporarily replace the intrusion sensor with a new or normally functioning sensor (Click here).

  1. Check if DTC B2761 is not output.

    OK:
    DTC B2761 is not output.



NG
Go to step 3
OK

END (INTRUSION SENSOR IS FAULTY)

3. CHECK MAP LIGHT ASSEMBLY (OPERATION)
  1. Temporarily replace the map light with a new or normally functioning one (Click here).

  1. Check if DTC B2761 is not output.

    OK:
    DTC B2761 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (MAP LIGHT ASSEMBLY IS FAULTY)


← DIAGNOSTIC TROUBLE CODE CHART (from Jan 2012)B2761 Intrusion Sensor Internal Circuit Malfunction (from Jan 2012) →