2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
When only replacing the room light bulbs, use the following procedures.


1. REMOVE MAP LIGHT ASSEMBLY (w/ Sliding Roof)
  1. Using a screwdriver, detach the 2 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 screws.

  1. Detach the 2 clips and 2 guides.

  1. Disconnect the connector and then remove the map light.

    B181713E01


2. REMOVE MAP LIGHT ASSEMBLY (w/o Sliding Roof)
  1. Using a screwdriver, detach the 2 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 screws.

  1. Detach the 2 clips and 2 guides.

  1. Disconnect the connector and then remove the map light.

    B181713E01


3. REMOVE MAP LIGHT BULB

  1. E155893
    Turn the 2 map light bulbs in the direction indicated by the arrows and remove them.

← ON-VEHICLE INSPECTION (from Sep 2011)INSTALLATION (from Sep 2011) →