P0818 Driveline Disconnect Switch Input Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The ECM detects the signal indicating that the transfer is in neutral.This DTC indicates that the signal indicating that the transfer is in neutral remains on.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0818 |
The signal indicating that the transfer is in neutral remains on while the vehicle is running under the following conditions for 30 sec. (2 trip detection logic):
|
|
MONITOR DESCRIPTION
The ECM detects whether or not the transfer is in neutral by monitoring the signal from the transfer shift actuator assembly.If the ECM detects that the transfer is in neutral under the following conditions, the ECM will conclude that there is a malfunction of the transfer shift actuator assembly, illuminate the MIL and store the DTC:
- The transfer shift actuator assembly indicates that the transfer is in neutral.
- The transfer position switch is in the H4 position.
- The vehicle is being driven at 25 km/h (16 mph) or more.
- The transfer neutral signal has been on for more than 30 seconds.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND) |
Disconnect the C38 transfer shift actuator assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
C38-3 (N) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND) |
![]() ![]() |
Disconnect the A27 four wheel drive control ECU connector.
Disconnect the C38 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A27-16 (NP) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (TRANSFER SHIFT ACTUATOR ASSEMBLY, FOUR WHEEL DRIVE CONTROL ECU - ECM) |
![]() ![]() |
Disconnect the A38 ECM connector (for LHD).
Disconnect the A52 ECM connector (for RHD).
Disconnect the C38 transfer shift actuator assembly connector.
Disconnect the A27 four wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection
Condition
Specified Condition
A38-39 (TFN) - Body ground
Always
10 kΩ or higher
for RHD Tester Connection
Condition
Specified Condition
A52-39 (TFN) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||


