2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

HINT:
*: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CONNECT GTS TO DLC3

        HINT:
        If the display indicates a communication fault with the GTS, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.

      NEXT

      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Check for DTCs (Click here) and freeze frame data (Click here).

        HINT:
        Record or print DTCs and freeze frame data if necessary.

      NEXT

      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Clear DTCs and freeze frame data (Click here).

      NEXT

      6.CONDUCT VISUAL INSPECTION
        NEXT

        7.CONFIRM PROBLEM SYMPTOMS

          HINT:
          If the engine does not start, first perform the "Check DTC" and "Basic Inspection" procedures below.

          Result 
          Result
          Proceed to
          Malfunction occurs
          A
          Malfunction does not occur
          B

        B.
        A

        8.CHECK DTC*

          HINT:
          Refer to DTC Check / Clear (Click here).

          Result 
          Result
          Proceed to
          Trouble code
          A
          No trouble code
          B

        B.
        A

        9.CONDUCT BASIC INSPECTION
        1. Conduct basic inspection (Click here).

        2. Result 
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B

        B.
        A

        10.REFER TO PROBLEM SYMPTOMS TABLE

          HINT:
          1. Refer to Problem Symptoms Table (Click here).
          2. Also, refer to the inspection procedure for the problem symptom.

        NEXT

        11.PARTS INSPECTION
          NEXT

          12.IDENTIFY PROBLEM
            NEXT

            13.ADJUST AND/OR REPAIR
              NEXT

              14.CONFIRMATION TEST
                NEXT

                ← SYSTEM DESCRIPTION (from Jan 2012)CHECK FOR INTERMITTENT PROBLEMS (from Jan 2012) →