2011-2013 Land Cruiser · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it is spilled on any painted surface.


3. REMOVE FRONT DISC BRAKE PAD

  1. C165344
    Remove the pin hold clip.

    NOTICE:
    The pin hold clip can be reused if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign particles cleaned off.

  1. Remove the 2 hole pins.

  1. C170925
    Remove the front disc brake anti-rattle spring.

    NOTICE:
    The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign particles cleaned off.

  1. C170926
    Remove the 2 pads from the disc brake caliper.

  1. Remove the No. 1 anti-squeal shims from each pad.


4. DISCONNECT FRONT FLEXIBLE HOSE

  1. C165345
    Remove the union bolt and gasket, and then disconnect the flexible hose.


5. REMOVE DISC BRAKE CALIPER ASSEMBLY LH

  1. C165346
    Remove the 2 bolts and disc brake caliper from the knuckle.


6. REMOVE FRONT DISC

  1. C170927E01
    Put matchmarks on the front disc and axle hub if planning to reuse the disc.

  1. Remove the front disc.

← COMPONENTS (from Sep 2011)DISASSEMBLY (from Sep 2011) →