Removal / installation · Vehicles built from Sep 2011
HINT:
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.
REMOVE FRONT DISC BRAKE PISTON SET RING
Using a screwdriver, remove the 4 set rings from the 4 cylinder boots.
HINT:
Tape the screwdriver tip before use.
2.
REMOVE CYLINDER BOOT
Using a screwdriver, remove the 4 cylinder boots from the disc brake caliper.
HINT:
Tape the screwdriver tip before use.
3.
REMOVE FRONT DISC BRAKE PISTON
Install one side of the disc brake pad.
Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.
Using an air gun, gradually apply air and remove the 2 disc brake pistons from the cylinder.
CAUTION:
Do not place your fingers in front of the pistons when using air gun.
Remove the brake pad and wooden plate.
Temporarily install the 2 disc brake pistons that were removed. Then install the disc brake pad to the side in which the 2 disc brake pistons are temporarily installed.
Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.
Using an air gun, gradually apply air and remove the 2 disc brake pistons from the other side of the cylinder.
CAUTION:
Do not place your fingers in front of the pistons when using air gun.
4.
REMOVE PISTON SEAL
Using a screwdriver, remove the 4 piston seals from the disc brake caliper.
NOTICE:
Do not damage the inner cylinder and cylinder groove.