2011-2013 Land Cruiser · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT TORQUE CONVERTER ASSEMBLY

  1. Inspect the 1-way clutch.

    1. C151051
      Press on the serrations of the stator with a finger and rotate the stator. Check that it rotates smoothly when turned clockwise and locks when turned counterclockwise.
      If necessary, clean the converter and recheck the 1-way clutch.
      Replace the converter if the 1-way clutch still fails the inspection.
      Text in Illustration 
      V100136
      Free
      V100135
      Lock

  1. D025367E35
    Determine the condition of the torque converter.
    Text in Illustration 
    *a
    Sample showing maximum allowable amount of powder in ATF

    1. If the inspection result of the torque converter satisfies the following conditions, replace the torque converter.

      Malfunction
      1. A metallic sound is emitted from the torque converter during the stall test or when the shift lever is moved to N.
      2. The 1-way clutch is free or locks in both directions.
      3. The amount of powder in the ATF is more than the sample shown in the illustration (see the sample).

      HINT:
      The sample shows approximately 0.025 liters (0.026 US qts, 0.022 Imp. qts) of ATF that was taken out from a removed torque converter.

  1. Replace the ATF in the torque converter.

    1. If the ATF is discolored and/or has a foul odor, stir the ATF in the torque converter thoroughly and drain the ATF with the torque converter facing upward.

  1. C011090
    Clean and check the oil cooler and oil pipe line.

    1. If the torque converter is inspected or the ATF is replaced, clean the oil cooler and oil pipe line.

      HINT:
      1. Apply compressed air at 196 kPa (2.0 kgf/cm2, 28 psi) into the inlet hose.
      2. If a large amount of powder is found in the ATF, add new ATF using a bucket pump and clean the oil cooler and oil pipe again.

    2. If the ATF is cloudy, inspect the oil cooler.

  1. D025368E36
    Prevent deformation of the torque converter and damage to the oil pump gear.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect
    *c
    Bottom is damaged

    1. When there is any damage to the end of a bolt for the torque converter and to the bottom of the bolt hole, replace the bolt and the torque converter.

    2. All of the bolts should be the same length.

    3. Bolts with washers must be used.


INSPECT DRIVE PLATE
  1. Check the drive plate for damage.

  1. C190458E06
    Set up a dial indicator and measure the runout of the 6 portions around the torque converter contact surfaces.
    Text in Illustration 
    *1
    Measurement point

    Maximum runout:
    0.30 mm (0.0118 in.)

    If the runout is not within the specification or the drive plate is damaged, replace the drive plate.
    for 3UR-FE (Click here)
    for 1VD-FTV (Click here)

← REASSEMBLY (from Jan 2012)INSPECTION (from Jan 2012) →