INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bush.
- Standard inside diameter:
- 45.064 to 45.078 mm (1.774 to 1.775 in.)
- If the inside diameter is more than the standard, replace the oil pump body sub-assembly.
| INSPECT STATOR SHAFT ASSEMBLY |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bush.
- Standard inside diameter:
- 25.900 to 25.921 mm (1.020 to 1.021 in.)
- If the inside diameter is more than the standard, replace the stator shaft assembly.
| INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() ![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the body clearance.
- Standard body clearance:
- 0.10 to 0.17 mm (0.00394 to 0.00669 in.)
- Maximum body clearance:
- 0.17 mm (0.00669 in.)
- If the body clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly.
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.

- Standard tip clearance:
- 0.070 to 0.150 mm (0.00276 to 0.00591 in.)
- Maximum tip clearance:
- 0.150 mm (0.00591 in.)
- If the tip clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly.
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.03 to 0.05 mm (0.00118 to 0.00197 in.)
- Maximum side clearance:
- 0.05 mm (0.00197 in.)
- HINT:
- There are 7 different thicknesses for the drive and driven gears.
- Standard Drive and Driven Gears Thickness:
Mark
Thickness
0
11.636 to 11.642 mm (0.4581 to 0.4583 in.)
1
11.643 to 11.649 mm (0.4584 to 0.4586 in.)
2
11.650 to 11.656 mm (0.4587 to 0.4589 in.)
3
11.657 to 11.663 mm (0.4589 to 0.4592 in.)
4
11.664 to 11.670 mm (0.4592 to 0.4594 in.)
5
11.671 to 11.677 mm (0.4595 to 0.4597 in.)
6
11.678 to 11.684 mm (0.4598 to 0.4600 in.)
| INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION |
![]() ![]() |
Place the oil pump body on the torque converter clutch.
Check that the drive gear rotates smoothly.
Remove the oil pump assembly from the torque converter.




