2011-2013 Land Cruiser · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL FRONT OIL PUMP OIL SEAL

C161807E01
  1. Using SST and a hammer, tap in a new oil seal.

    SST
    09950-60010   (09951-00650)
    09950-70010   (09951-07100)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.


2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

C161799
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

C161798
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.


5. INSTALL FRONT OIL PUMP BODY O-RING

C161797E01
  1. Coat a new O-ring with ATF and install it to the oil pump body.


6. INSTALL STATOR SHAFT ASSEMBLY

C161796E01
  1. Align the stator shaft with the bolt holes.

  1. Install the 17 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }


7. INSTALL CLUTCH DRUM OIL SEAL RING

C161795E02
  1. Coat 3 new oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together so that the overlap distance is 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not excessively widen the rings.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


8. INSPECT OIL PUMP DRIVE GEAR ROTATION

C161806
  1. Place the oil pump body on the torque converter clutch.

  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.


9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING

C162762E01
  1. Coat a new O-ring with ATF and install it to the oil pump.

← INSPECTION (from Sep 2011)PROBLEM SYMPTOMS TABLE (from Sep 2011) →