2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK GLOW PLUG ASSEMBLY

A163041E01
  1. Remove the screw grommet.

  1. Remove the glow plug connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Glow plug terminal - Body ground
    20°C (68°F)
    Approximately 1 Ω

    1. If the result is not as specified, replace the glow plug assembly.

    NOTICE:
    1. Be careful not to damage the glow plug, as this may cause an open circuit or shorten the life of the glow plugs.
    2. Do not allow oil or gasoline to contact the glow plug when cleaning it.
    3. Clean any oil on the terminal and bakelite washer with a dry cloth.
    4. Do not apply more than 11 V to the glow plug, as this may cause an open circuit.

← COMPONENTS (from Jan 2012)ON-VEHICLE INSPECTION (from Jan 2012) →