2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK GLOW PLUG ASSEMBLY
  1. Remove the glow plug connector (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Item
    Tester Connection
    Condition
    Specified Condition
    w/ DPF
    Glow plug terminal - Body ground
    20°C (68°F)
    0.7 Ω or higher
    w/o DPF
    Approximately 1 Ω

    NOTICE:
    1. Be careful not to damage the glow plug, as this may cause an open circuit or shorten the life of the glow plugs.
    2. Do not allow oil or gasoline to contact the glow plug when cleaning it.
    3. Clean any oil on the terminal and bakelite washer with a dry cloth.
    4. Do not apply more than 11 V to the glow plug, as this may cause an open circuit.

    1. If the result is not as specified, replace the glow plug assembly.

  1. Install the glow plug connector (Click here).

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)REMOVAL (Sep 2011 – Dec 2011) →