2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and under cover.


4. REMOVE UPPER RADIATOR SUPPORT SEAL

  1. B180889
    Remove the 7 clips and radiator support seal.


5. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }


    A174296E01

  1. Tighten the radiator drain cock plug by hand.


6. REMOVE V-BANK COVER

  1. A174355
    Remove the 2 cap nuts and V-bank cover.


7. REMOVE NO. 1 RADIATOR HOSE

  1. A174326
    Remove the radiator hose.


8. REMOVE NO. 2 RADIATOR HOSE

  1. A174327
    Remove the radiator hose.


9. DISCONNECT OIL COOLER TUBE (w/ Air Cooled Transmission Oil Cooler)

  1. A177205
    Detach the claw to open the flexible hose clamp, and then remove the 2 bolts to disconnect the oil cooler tube from the fan shroud.


10. REMOVE FAN SHROUD

  1. A174319
    Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the fan and generator V-belt (Click here).

  1. A174320
    Disconnect the reservoir hose from the upper side of the radiator tank.

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


11. REMOVE NO. 2 AIR CLEANER HOSE

  1. A178932
    Loosen the 2 hose clamps and remove the air cleaner hose.


12. REMOVE AIR CLEANER ASSEMBLY

  1. A151812
    Disconnect the No. 2 ventilation hose.

  1. Detach the hose clamp.

  1. A185261
    Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Using a clip remover, detach the 2 wire harness clamps.

  1. A151770
    Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner assembly.


13. REMOVE WATER INLET HOUSING

  1. A174303
    Disconnect the 2 oil cooler hoses.

  1. A243260
    Disconnect the 5 water by-pass hoses.

  1. A174305
    Remove the 5 bolts and water inlet.

  1. Remove the gasket from the water outlet pipe.

  1. Remove the gasket from the water pump.


14. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

  1. A191314E01
    w/ Pulley Cover Plate:
    Remove the 2 bolts, 2 No. 2 idler pulley cover plate, 2 idler pulley and 2 idler pulley cover plate.

  1. A076338E01
    w/o Pulley Cover Plate:
    Remove the 2 bolts and 2 No. 2 idler pulleys.


15. REMOVE GENERATOR ASSEMBLY

  1. A180582
    Remove the nut and disconnect the wire harness clamp bracket.

  1. A177921
    Disconnect the generator connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the generator wire.

  1. Remove the wire harness clamp.

  1. Remove the bolt and disconnect the wire harness clamp bracket.

  1. A177920
    Remove the 2 bolts and generator.


16. DISCONNECT COOLER COMPRESSOR ASSEMBLY
  1. Disconnect the cooler compressor connector.

  1. A174379
    Remove the nut, 3 bolts and stud bolt, and disconnect the cooler compressor.


17. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

  1. A175285
    Remove the 5 bolts and V-ribbed belt tensioner.


18. REMOVE WATER PUMP ASSEMBLY

  1. A174307
    Remove the 17 bolts, water pump and gasket.

← ON-VEHICLE INSPECTION (from Jan 2012)REMOVAL (from Jan 2012) →