2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted

Circuit diagnosis · Vehicles built from Jan 2012

INSPECTION PROCEDURE

HINT:
If an outlet of the air conditioning system is facing the microphone, noise may be recorded and the other caller may not be able to hear your voice properly.


1. CHECK CELLULAR PHONE
  1. Check if the other caller can hear your voice properly.

    OK:
    Your voice can be heard properly.

    HINT:
    The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.



NG
REPLACE CELLULAR PHONE
OK


2. CHECK SETTINGS

  1. E226625E01
    Display the "Call" screen.

  1. Check if the "Mute" switch is set to on.

    OK:
    "Mute" switch is not set to on.

    Text in Illustration 
    *a
    Example



NG
TURN "Mute" SWITCH OFF
OK


3. CHECK MICROPHONE (OPERATION CHECK)

  1. E187218
    Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Select the recording switch and perform voice recording.

    1. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
    2. Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)


← The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (from Jan 2012)Black Screen (from Jan 2012) →