2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT INTAKE AIR TEMPERATURE SENSOR

A164295E01
  1. Partially immerse the sensor in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Approximately 20°C (68°F)
    2.21 to 2.65 kΩ
    1 - 2
    Approximately 60°C (140°F)
    0.55 to 0.61 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →