INSTALLATION
Removal / installation · Vehicles built from Sep 2011
| 1. INSTALL INTAKE AIR TEMPERATURE SENSOR (w/o Intercooler) |
Using a 22mm deep socket wrench, install the sensor and a new gasket.
- Torque:
- 34 N*m{ 347 kgf*cm , 25 ft.*lbf }
| 2. INSTALL INTAKE AIR TEMPERATURE SENSOR (w/ Intercooler) |
Using a ball joint lock nut wrench, install the sensor and a new gasket.

- Torque:
- 29 N*m{ 300 kgf*cm , 22 ft.*lbf }
- NOTICE:
- Do not use a tool such as an impact wrench or equivalent.
- HINT:
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
- Make sure SST and the wrench are connected in a straight line.
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
| 3. INSTALL INTERCOOLER ASSEMBLY (w/ Intercooler) |
