OPERATION CHECK
Troubleshooting · Vehicles built from Sep 2011
| CHECK WINDOW LOCK SWITCH |
![]() ![]() |
- HINT:
- Before performing the window lock switch operation check, make sure that the window lock switch is off (the switch is not pushed in).
Check that the front passenger side power window and the rear power windows cannot be operated when the window lock switch of the multiplex network master switch is pressed.
- OK:
- Operation of front passenger side power window and rear power windows are disabled.
Check that the front passenger side power window and the rear power windows can be operated when the window lock switch is pressed again.
- OK:
- Front passenger side power window and rear power windows can be operated.
| CHECK MANUAL UP/DOWN FUNCTION |
Check that the driver side power window operates as follows:
OK Condition
Multiplex Network Master Switch
Switch Operation
Power Window
Ignition switch ON
Driver side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
Check that the front passenger side and rear power windows operate as follows:
OK Condition
Power Window Regulator Switch
Switch Operation
Power Window
- Ignition switch ON
- Window lock switch off
Front passenger side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
Rear LH side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
Rear RH side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
- Ignition switch ON
| CHECK AUTO UP/DOWN FUNCTION |
Check that the driver side power window operates as follows:
OK Condition
Multiplex Network Master Switch
Switch Operation
Power Window
Ignition switch ON
Driver side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
Check that the front passenger side and rear power windows operate as follows:
OK Condition
Power Window Regulator Switch
Switch Operation
Power Window
- Ignition switch ON
- Window lock switch off
Front passenger side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
Rear LH side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
Rear RH side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
- Ignition switch ON
| CHECK REMOTE MANUAL UP/DOWN FUNCTION |
Check that the front passenger side and rear power windows operate as follows:
OK Condition
Multiplex Network Master Switch
Switch Operation
Power Window
- Ignition switch ON
- Window lock switch off
Front passenger side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
Rear LH side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
Rear RH side
Pulled halfway up
Up (Closes)
Pushed halfway down
Down (Opens)
- Ignition switch ON
| CHECK REMOTE AUTO UP/DOWN FUNCTION |
Check that the front passenger side and rear power windows operate as follows:
OK Condition
Multiplex Network Master Switch
Switch Operation
Power Window
- Ignition switch ON
- Window lock switch off
Front passenger side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
Rear LH side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
Rear RH side
Pulled up (One touch operation)
Auto up (Closes)
Pushed down (One touch operation)
Auto down (Opens)
- Ignition switch ON
| CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF |
Check that all the power windows can be operated with the multiplex network master switch after the ignition switch is turned off.
Check that the key-off operation function does not operate after a front side door is opened.
Check that all the power windows cannot be operated after more than approximately 45 seconds have elapsed since the ignition switch was turned off.
| CHECK TRANSMITTER-LINKED FUNCTION |
Check that all power windows operate as follows when operating the transmitter.
OK Condition
Transmitter Operation
Power Window
No key is inside vehicle, and all doors are closed and locked.
Unlock switch pressed for more than 3.0 sec.
Down (Opens)
No key is inside vehicle, and all doors are closed and locked.
Unlock switch released.
Stop
| CHECK KEY-LINKED FUNCTION USING DRIVER SIDE DOOR KEY CYLINDER |
Check that all power windows operate as follows.
OK Condition
Door Key Cylinder Operation
Power Window
No key is inside vehicle, and all doors are closed.
Turned to lock for more than 2.3 sec.
Up (Closes)
No key is inside vehicle, and all doors are closed.
Returned to neutral position.
Stop
No key is inside vehicle, and all doors are closed.
Turned to unlock for more than 2.3 sec.
Down (Opens)
No key is inside vehicle, and all doors are closed.
Returned to neutral position.
Stop
| CHECK AUTO UP FUNCTION USING ENTRY LOCK SWITCH (w/ Entry and Start System) |
Check that all power windows operate as follows when the entry lock switch is pressed and held.
OK Condition
Switch Operation
Power Window
No key is inside vehicle, and all doors are closed.
Entry lock switch pressed for more than 3.0 sec.
Up (Closes)
No key is inside vehicle, and all doors are closed.
Entry lock switch released.
Stop
| CHECK JAM PROTECTION FUNCTION |
Check the basic function.
- CAUTION:
- The jam protection function is operative during both the auto up and manual up operation.
- Do not put your fingers between the door frame and door glass to check functions. Also, prevent any part of your body from being caught during inspection.
- The jam protection function is operative during both the auto up and manual up operation.
- HINT:
- The jam protection function is operative during both the auto up and manual up operation while the engine is running or the ignition switch is ON, and also 45 seconds after the ignition switch is off.
Fully open the window.
Hold a thick book wrapped with cloth in the position shown in the illustration.

Operate the auto up or manual up function to check that the power window goes down when the window contacts the book, and stops when the opening reaches approximately 200 mm (7.87 in.).
- HINT:
- The power window moves down approximately 125 mm (4.93 in.). However, when the opening does not reach 200 mm (7.87 in.), the power window continues to go down until the opening reaches 200 mm (7.87 in.) or until approximately 5 seconds. have elapsed.
While the power window is moving down, check that the door glass cannot be moved up even when the power window regulator switch is used.
| CHECK POWER WINDOW REGULATOR SWITCH LED ILLUMINATION |
Check the LED illumination.
Check that the LED located on the power window regulator switch illuminates when the ignition switch is ON and the window lock switch is off.
