2011-2013 Land Cruiser · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE COOLER BRACKET

I104334
  1. Detach the 2 clamps.

  1. Remove the screw and the cooler bracket.


2. REMOVE MAGNET CLUTCH ASSEMBLY

I104335E01
  1. Clamp the cooler compressor in a vise.

  1. Using SST, hold the magnet clutch hub.

    SST
    09985-00270  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.

  1. I104018
    Using a snap ring expander, remove the snap ring and the magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.

  1. I104019
    Using a snap ring expander, remove the snap ring and magnet clutch stator.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →