2011-2013 Land Cruiser · Service Manual Vehicle Interior

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL MAGNET CLUTCH ASSEMBLY

I104345
  1. Install the magnet clutch stator with the parts shown in the illustration matched.

  1. I032461
    Using a snap ring expander, install a new snap ring with the chamfered side facing up.

  1. Connect the connector.

  1. I031582
    Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.

  1. Install the compressor washer(s) and magnet clutch hub.

    NOTICE:
    Do not change the combination of the compressor washer(s) used before disassembly.

  1. I104346E01
    Using SST, hold the magnet clutch hub and install the bolt.
    SST
    09985-00270  

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.


2. INSTALL COOLER BRACKET

I104342E01
  1. Install the cooler bracket with the screw.

  1. Attach the clamp.

    Text in Illustration 
    *1
    Cooler Bracket


3. INSPECT MAGNET CLUTCH CLEARANCE

I104347E04
  1. Clamp the cooler compressor in a vise.

  1. Set the dial indicator to the magnet clutch hub.

  1. Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

    Standard clearance:
    0.35 to 0.60 mm (0.014 to 0.024 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

    Compressor washer thickness:
    0.1 mm (0.004 in.)
    0.3 mm (0.012 in.)
    0.5 mm (0.020 in.)

    NOTICE:
    Adjustment should be performed with 3 or fewer magnet clutch washers.

  1. Remove the cooler compressor from the vise.

    Text in Illustration 
    *1
    Battery
    *a
    Component without harness connected
    (Magnet Clutch Assembly)

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →