2011-2013 Land Cruiser · Service Manual Drivetrain

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE FRONT AXLE INBOARD JOINT SET SETTING SHAFT SNAP RING

  1. C057543
    Using a screwdriver, remove the snap ring from the inboard joint shaft.


2. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT SETTING CLAMP
  1. Using a side cutter, cut the inboard joint boot setting clamp and remove it.


3. REMOVE FRONT NO. 1 AXLE INBOARD JOINT BOOT SETTING CLAMP
  1. Using a side cutter, cut the inboard joint boot setting clamp and remove it.


4. DISCONNECT FRONT AXLE INBOARD JOINT BOOT

  1. C177089E01
    Disconnect the inboard joint boot from the inboard joint shaft.


5. REMOVE FRONT AXLE INBOARD JOINT SHAFT

  1. C172549E01
    Place matchmarks on the inboard joint shaft and outboard joint shaft.

    NOTICE:
    Do not punch the marks.

  1. Using a screwdriver, remove the snap ring from the inboard joint shaft.

  1. Remove the inboard joint shaft from the outboard joint shaft.

  1. C115633E04
    Place matchmarks on the outboard joint shaft, inner race and cage.

    NOTICE:
    Do not punch the marks.

  1. Remove the 6 balls.

  1. Slide the cage to the outboard joint side.

  1. C158392
    Using a snap ring expander, remove the snap ring.

  1. C158393
    Using a brass bar and hammer, tap off the inner race.

    NOTICE:
    Be careful not to damage the inner race.

  1. Remove the cage.


6. REMOVE FRONT AXLE INBOARD JOINT BOOT
  1. Remove the inboard joint boot from the outboard joint shaft.


7. REMOVE FRONT NO. 1 AXLE OUTBOARD JOINT BOOT SETTING CLAMP
  1. Using a side cutter, cut the outboard joint boot setting clamp and remove it.


8. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT SETTING CLAMP
  1. Using a side cutter, cut the outboard joint boot setting clamp and remove it.


9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT

  1. C177229E01
    Remove the outboard joint boot from the outboard joint shaft.


10. REMOVE DUST SEAL

C222937
  1. Fix the outboard joint shaft assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a screwdriver and a hammer, remove the dust seal.


11. REMOVE FRONT DRIVE SHAFT DUST COVER LH

  1. C175797E01
    Using SST and a press, press out the dust cover.
    SST
    09950-00020  

    NOTICE:
    Do not drop the inboard joint shaft.

← REMOVAL (from Sep 2011)INSPECTION (from Sep 2011) →