2011-2013 Land Cruiser · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and No. 1 engine under cover.


4. REMOVE NO. 2 ENGINE UNDER COVER

  1. A178462
    Remove the 2 bolts and No. 2 engine under cover.


5. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. C174596
    for Front Differential:

    1. Remove the engine under cover.

    2. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    3. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    4. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the oil.

    3. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }


6. REMOVE FRONT AXLE ASSEMBLY LH
  1. Remove the front axle assembly (Click here).


7. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

  1. C171948E01
    Using SST, remove the drive shaft.
    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Be careful not to damage the dust cover and oil seal.

← COMPONENTS (from Jan 2012)DISASSEMBLY (from Sep 2011) →