2011-2013 Land Cruiser · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

C172095
  1. Detach the clamp, and disconnect the connector from the protector.

  1. Remove the 3 bolts and protector.


2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

  1. Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.

    C175131E01

    NOTICE:
    1. When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
    2. Do not remove the shutter valves.


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


4. DISCONNECT FRONT SPEED SENSOR LH

  1. C171981
    Remove the bolt, skid control sensor clamp and sensor wire.

  1. C171982
    Using a 5 mm hexagon socket, remove the bolt and speed sensor from the knuckle.

  1. NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.


5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
  1. Remove the front axle hub (Click here).


6. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.

  1. C179622E01
    Using SST, disconnect the tie rod end LH from the steering knuckle.
    SST
    09610-20012  

    NOTICE:
    1. Do not damage the front disc brake dust cover.
    2. Do not damage the ball joint dust cover.
    3. Do not damage the steering knuckle.


7. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

C173480
  1. Remove the 2 bolts and disconnect the attachment from the steering knuckle.


8. REMOVE STEERING KNUCKLE LH
  1. Support the front suspension lower arm LH with a jack.

  1. Remove the clip and nut.

  1. C155977E01
    Using SST, disconnect the upper ball joint from the steering knuckle.
    SST
    09628-62011  

    NOTICE:
    Do not damage the ball joint dust cover.

  1. Remove the steering knuckle.


9. REMOVE STEERING KNUCKLE OIL SEAL LH

  1. C179620
    Using a screwdriver and hammer, tap out the oil seal.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →