2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and under cover.


4. REMOVE UPPER RADIATOR SUPPORT SEAL

  1. B180889
    Remove the 7 clips and radiator support seal.


5. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }


    A174296E01

  1. Tighten the radiator drain cock plug by hand.


6. REMOVE V-BANK COVER

  1. A174355
    Remove the 2 cap nuts and V-bank cover.


7. REMOVE OIL FILTER SUB-ASSEMBLY
  1. Remove the drain pipe cap.

  1. A174331E01
    Using SST, remove the oil filter.
    SST
    09228-07501  

    HINT:
    1. Put the disposal container beneath the drain hose to collect the oil from the oil filter cover.
    2. Drain hose inside diameter: 8 mm (0.315 in.)
    3. Drain hose length: 900 mm (2.95 ft.)


8. REMOVE OIL COOLER ASSEMBLY

  1. A174351
    Remove the oil cooler hose and No. 2 oil cooler hose.

  1. A174352
    Remove the union bolt, plate washer and oil cooler.

  1. Remove the O-ring from the oil cooler.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →