2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the low and full level marks on the dipstick.
    If the oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


INSPECT OIL PRESSURE
  1. Disconnect the oil pressure sensor connector.

  1. Using a 24 mm deep socket wrench, remove the oil pressure sensor.

  1. A174328E01
    Install an oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idling
    29 kPa (0.3 kgf/cm2, 4.2 psi) or more
    3000 rpm
    294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi)

    If the oil pressure is not as specified, check the oil pump.

  1. Remove the oil pressure gauge.

  1. A174329E01
    Apply adhesive to 2 or 3 threads of the oil pressure sensor.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    NOTICE:
    Do not apply adhesive to the oil inlet port of the sensor.

  1. Using a 24 mm deep socket wrench, install the oil pressure sensor.

    Torque:
    15 N*m{ 150 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour of installation.

  1. Connect the oil pressure sensor connector.

  1. Start the engine and check for engine oil leaks.

← INSTALLATION (from Jan 2012)ON-VEHICLE INSPECTION (from Jan 2012) →