ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| INSPECT OIL QUALITY |
Check the oil for deterioration, water contamination, discoloration or thinning.
If the quality is visibly poor, replace the oil and oil filter element (Click here).
| INSPECT ENGINE OIL LEVEL |
Warm up the engine, and then stop the engine and wait for 5 minutes.
Check that the engine oil level is between the low level and full level marks on the dipstick.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill engine oil above the full level mark.
| INSPECT OIL PRESSURE |
Remove the oil pressure switch (Click here).
Install an oil pressure gauge.

Text in Illustration *1
Oil Pressure Gauge
Warm up the engine.
Inspect the oil pressure.
- Standard Oil Pressure:
Condition
Specified Condition
Idling
30 kPa (0.3 kgf/cm2, 4.4 psi) or higher
3000 rpm
200 kPa (2.0 kgf/cm2, 29 psi) or higher
Remove the oil pressure gauge.
Install the oil pressure switch (Click here).
