2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

01-DC Transmission Error

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
01-DC
*1
Transmission to component shown by sub-code failed (Detecting this DTC does not always mean actual failure).
If the same sub-code is stored in other components, check power source circuit and communication system of all components shown by sub-code

HINT:
*1: If the engine switch is turned off after idling for 60 seconds, this DTC may be stored when the engine is started again.

NOTICE:
  1. Before starting troubleshooting, be sure to clear the DTCs stored due to the reason described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  2. The radio receiver assembly is the master unit.
  3. Be sure to clear and recheck for the DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read Description before performing the following procedure.


1. CHECK FOR DTC OF OTHER COMPONENTS
  1. Check if the component shown by the sub-code is displayed in the check result of the other components.

    1. Check if "01-DC" is output for the other components.

    2. If "01-DC" is output for any other components, check if the same physical address is displayed.

      Result 
      Result
      Proceed to
      "01-DC" is output and the same physical address is displayed
      A
      "01-DC" is not output or the same physical address is not displayed
      B

      HINT:
      For the list of the components shown by sub-codes, refer to the table in step 2.



B
Go to step 4
A


2. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE

  1. Enter diagnostic mode.E110915E13

  1. Press preset switch "2" to change the mode to "Detailed Information Mode".

  1. Identify the component which has stored this code.

    Component Table 
    Component
    Physical Address
    Stereo component amplifier assembly
    440
    Radio receiver assembly
    190
    Multi-media interface ECU
    388

    HINT:
    1. "P440" set by the stereo component amplifier assembly is shown in the preceding illustration as an example.
    2. For details of the DTC display, refer to DTC Check/Clear (Click here).


NEXT


3. CHECK COMPONENT WHICH HAS STORED THIS CODE
  1. Select the component which has stored this code.

    Component Table 
    Component
    Proceed to
    Stereo component amplifier assembly
    Stereo component amplifier communication error (Click here)
    Radio receiver assembly
    Radio receiver communication error (Click here)
    Multi-media interface ECU
    Multi-media interface ECU communication error (Click here)


NEXT

END

4. CLEAR DTC
  1. Clear the DTCs (Click here).

    HINT:
    If "01-DC" is output for only one component, this may not indicate a malfunction.


NEXT


5. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

    OK:
    Malfunction disappears.



NG
Go to step 6
OK

END

6. CHECK COMPONENT WHICH HAS STORED THIS CODE
  1. Select the component which has stored this code.

    Component Table 
    Component
    Proceed to
    Stereo component amplifier assembly
    Stereo component amplifier communication error (Click here)
    Radio receiver assembly
    Radio receiver communication error (Click here)
    Multi-media interface ECU
    Multi-media interface ECU communication error (Click here)


NEXT

END


← 01-D6 No Master (+ 01-D7) (from Jan 2012)01-DC Transmission Error (from Jan 2012) →