4. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)
HINT:
Start the check from the circuit that is near the component shown by the sub-code first.
For details of the connectors, refer to Terminals of ECU (Click here).
Referring to the following AVC-LAN wiring diagram, check the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.
Disconnect all connectors between the stereo component amplifier assembly and component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the stereo component amplifier assembly and component shown by the sub-code.
OK:
There is no open or short circuit.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5. REPLACE COMPONENT SHOWN BY SUB-CODE
Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.