2011-2013 Land Cruiser · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE GENERATOR PULLEY

A162627E01
SST
09820-63011   (09820-06010, 09820-06021)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06021

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.

  1. B016524E04
    Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.

  1. A163073E01
    To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.

  1. A162628E01
    Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.


2. REMOVE GENERATOR REAR END COVER

  1. A177975
    Place the generator on the pulley.

  1. Remove the 3 nuts and end cover.

  1. A177976
    Remove the terminal insulator.


3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A177977
    Remove the 2 screws and brush holder.


4. REMOVE GENERATOR COIL ASSEMBLY

  1. A177978
    Remove the 4 bolts.

  1. A177979E01
    Using SST, remove the coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


5. REMOVE GENERATOR ROTOR ASSEMBLY
  1. Remove the generator washer.

  1. Remove the generator rotor assembly from the generator drive end frame.


6. REPLACE GENERATOR DRIVE END FRAME BEARING

  1. B016375E01
    Remove the 4 screws and retainer plate.

  1. B016518E01
    Using SST and a hammer, tap out the bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

  1. B016515E01
    Using SST and a press, press in a new bearing.
    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. B016375E01
    Install the retainer plate with the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →