2011-2013 Land Cruiser · Service Manual Power Source / Network

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL GENERATOR ROTOR ASSEMBLY

  1. A163025
    Place the drive end frame on the pulley.

  1. Install the rotor to the drive end frame.


2. INSTALL GENERATOR COIL ASSEMBLY

  1. A178036E01
    Place the generator washer on the rotor.

  1. B016512
    Using a 21 mm socket wrench and a press, slowly press in the coil assembly.

  1. A178034E01
    130 A Type and 150 A Type:
    Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }

  1. 180 A Type:
    Install the 4 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }


3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A163028E01
    While pushing the 2 brushes toward the inside of the brush holder, insert a pin (diameter: 1.0 mm (0.0394 in.)) into the brush holder hole.

  1. A178043E01
    Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.


4. INSTALL GENERATOR REAR END COVER

  1. A178032E01
    Install the terminal insulator to the generator rectifier end frame.

    NOTICE:
    Pay attention to the mounting orientation of the terminal insulator.

  1. A178044E01
    Install the end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 46 kgf*cm , 40 in.*lbf }


5. INSTALL GENERATOR PULLEY

A156429E01
SST
09820-63011   (09820-06010, 09820-06021)

HINT:
SST 1-A and 1-B
09820-06010
SST 2
09820-06021

  1. Install the pulley onto the rotor shaft by tightening the pulley nut by hand.

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured to the rotor shaft.

  1. A156430E01
    Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.

  1. A163027E01
    Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.

    Torque:
    133 N*m{ 1351 kgf*cm , 98 ft.*lbf }

  1. Remove the generator from SST 2.

  1. A156432E01
    Turn SST 1-B, and remove SST 1-A and 1-B.

  1. Turn the pulley and check that the pulley moves smoothly.

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →