2011-2013 Land Cruiser · Service Manual Power Source / Network

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A163021
    Rotate the bearing and check that there is no abnormal noise and that it rotates smoothly.
    If necessary, replace the bearing (Click here).


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A178037E01
    Check the rotor for an open circuit.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      130 A Type 
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      2.3 to 2.7 Ω
      150 A Type 
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      1.5 to 1.9 Ω
      180 A Type 
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      1.36 to 1.76 Ω

      If the result is not as specified, replace the rotor assembly.

  1. A178038E01
    Check if the rotor is grounded.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor
      Always
      10 kΩ or higher

      If the result is not as specified, replace the rotor assembly.

  1. Check that the slip rings are not rough or scored.
    If rough or scored, replace the rotor assembly.

  1. A178039E01
    Using a vernier caliper, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the rotor assembly.


INSPECT GENERATOR ROTOR BEARING

  1. A178042E01
    Rotate the bearing and check that there is no abnormal noise and that it rotates smoothly.
    If necessary, replace the generator rotor.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A163020E01
    Using a vernier caliper, measure the exposed brush length.

    Standard exposed length:
    10.5 mm (0.413 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    If the exposed length is less than the minimum, replace the brush holder assembly.

← DISASSEMBLY (from Sep 2011)REASSEMBLY (from Sep 2011) →