2011-2013 Land Cruiser · Service Manual Steering

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011

NOTICE:
When using a vise, do not overtighten it.


1. REMOVE POWER STEERING SUCTION PORT UNION
  1. Remove the bolt and suction port union from the vane pump.

  1. Using a screwdriver, remove the O-ring from the suction port union.


2. REMOVE FLOW CONTROL VALVE

C162100
  1. Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and compression spring.


3. REMOVE VANE PUMP GEAR

  1. C162114E01
    Using soft jaws on a vise, clamp the vane pump.

    NOTICE:
    Be careful not to damage the vane pump.

  1. Using SST, remove the gear.

    SST
    09950-30012   (09951-03010, 09953-03010, 09954-03010, 09955-03011)


4. REMOVE REAR VANE PUMP HOUSING

  1. C162098
    Remove the 4 bolts and rear housing from the front housing.

  1. C162099E01
    Using a screwdriver, remove the O-ring from the rear housing.

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE VANE PUMP ROTOR, 10 VANE PUMP PLATES AND VANE PUMP CAM RING
  1. Remove the 10 vane pump plates.

    NOTICE:
    Take care not to drop the vane pump plates.

  1. Remove the rotor.

  1. Remove the cam ring from the front housing.


6. REMOVE VANE PUMP FRONT SIDE PLATE
  1. Remove the front side plate from the front housing.

  1. C162121E01
    Using a screwdriver, remove the O-ring from the front side plate.

    HINT:
    Tape the screwdriver tip before use.

  1. C162123
    Remove the O-ring from the front housing.


7. REMOVE VANE PUMP SHAFT WITH VANE PUMP SHAFT BEARING

  1. C161392E01
    Using a screwdriver, remove the snap ring.

    NOTICE:
    Be careful not to damage the front housing.

    HINT:
    Tape the screwdriver tip before use.

  1. C164630E01
    Tape the serrated part of the vane pump shaft.

  1. C161393
    Using a press, press out the shaft with bearing.


8. REMOVE VANE PUMP SHAFT BEARING

  1. C162115
    Using 2 screwdrivers, remove the snap ring from the shaft.

    NOTICE:
    Be careful not to damage the shaft.

  1. C162117
    Using a press, press out the bearing from the shaft.


9. REMOVE VANE PUMP HOUSING OIL SEAL

  1. C161396
    Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the front housing.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (from Jan 2012)INSPECTION (from Sep 2011) →